Tyres are probably the most exposed parts of a vehicle, and they are affected by various particles present on the road. Tyres often come in contact with the sharp objects present on the road, and upon impact, these objects rupture the tyre’s outer wall. Therefore, the air starts to slip out gradually, and the tyres go flat.

There are basically two types of punctures, slow and rapid. Rapid punctures happen when the sharp objects that come in contact with the tyres are very large, damaging the tyres beyond repair. In the case of rapid punctures, you have to replace the tyre. However, slow punctures are fairly manageable, and they can be self-repaired. Here is an article on how to fix a punctured tyre.

Tips To Fix A Punctured Tyre
Park the car safely: When Pirelli tyres Newport get punctured, they lose the air pressure and get heavy on the steering. Driving under low pressure can cause the tyres to burst, which is a huge safety concern. Therefore, if you suspect punctured tyres, pull up the car at the side of the road and apply the handbrakes.

Now, switch on the parking lights so that the vehicles following you are signalled about a breakdown. If you carry safety cones with you, place them around your vehicle to make a safe zone for repair.

If you are on a slope, look for some medium-sized rocks around you and place them near every tyre for extra protection. Sometimes, due to external force, the car slides off the slope and takes greater damage.

Draw out the tools: Do not wait for the car to go off the ground; instead, take out all the essentials from the boot as soon as you park the car. Once the car is suspended on the jack, any extra movement will risk the car-jack’s breakdown, and the vehicle may slide down. Arrange all the tools around the affected tyre to save time on the repair.

Place the car-jack properly: First, locate the vehicle’s midpoint along the vertical alignment and then place the jack accordingly. It is advised to carry two jacks at all times to get an even lift out of it. Also, two jacks help to divide the carload and ensure better stability evenly. Additionally, ensure that the jack used is compatible with the car’s weight so that it doesn’t break down in the middle of the process.

Pull out the tyre and locate the puncture: Once you have lifted the car, unscrew the affected tyre and pull it out. Now locate the point that caused the puncture; if you find a sharp object stuck in an outer wall, note the dimensions. If the hole is wider than 6mm, do not pull out the object; simply inflate your Cheap tyres Cwmbran and look for the nearest garage. However, if the hole is less than 6mm, it’s easily repairable.

Seal the hole: Once you have located the puncture, pull out the sharp object carefully. Now, fill the hole with the seal that comes with the toolkit. The seal comes in two variants, solid and liquid. If you have a solid seal, you will need an air compressor to put it into place firmly. Once you have applied the seal, roll the tyres over to ensure that the seal is tightened.

If you have a liquid seal, pour it into the tube through the valve. Liquid seal moves through the inner tube and seals the affected area from within. This is just a general idea, and many different brands have different application processes. For this reason, carefully read the instruction manual that came with the seal.